1.) For best results make sure your flower is dry so that it's conducive for vaporization. 

  • Tip: You can leave your dry herb out on a piece of paper for 10-15 minutes prior to packing it. 

2.) Grind your flower to a medium grind

3.) Fill the crucible lightly, don't cram it full. 

4.) Make sure you're using one of the 5 Herb Settings (see legend above)

  • The MV1 was designed to deliver both the full flavor of your material and a potent hit. The following sequence is predicated on providing this experience. 


    * Start your session on Heat setting Herb - Low (1 amber LED)
    * Next, take two draws on Herb - High (3 amber LED)
    * Finally, finish your crucible on Herb - Fav 1 or 2 (1 or 2 red LED)

5.) For the best results, take 10-second draws

6.) It's not a race: spread your inhale out so that you're able to comfortably draw at a consistent rate for the full 10 seconds
7)  Inhale with your diaphragm ( learn how here >>> What's the Best Way to Hit the MV1? )
8.) A typical session with flower is comprised of 6-8 draws
9.) Adjust speed and strength of draw as needed
10.) Adjust mouthpiece position as needed (higher the position, less resistance; lower the position, more resistance)

11.) For a breakdown of the draw sequence please click here >>> (When Do I Take My Draw?)


+EXTRAS
* The higher the heat setting, the more heat that's created, resulting in more vapor. The higher in heat you go, the less flavor you will experience.

* Heat Setting 1 (1 Amber LED) was designed to enable a discreet vaping experience where there's little to no vapor. You will experience the full flavor of your material on this setting however.
* Material does play a role in your experience. For instance, if you're vaporizing the natural herbs that we sell on our site you will likely get no vapor